Physical properties 
 1, the chemical composition of nylon plus fiberglass primer water: Polymer Interface polymer. 2, nylon and fiberglass primer water density (g/cm3): 0.90, nylon plus fiberglass primer water Flash Point: about 12 ℃. 4, nylon plus fiberglass primer water Appearance: light yellow transparent liquid. 

 Use 
 Nylon plus fiberglass primer water specifically used in the plastics processing of the PA to enhance the special coating on the substrate adhesion additives. Widely used in many aspects of home appliances, commodity, toys and other nylon plus fiberglass primer water, in order to make products to achieve a high level in appearance, surface finishing, PA plastic surface is poor, low-polarity often poor adhesion, the need for special treatment. Such as: Flame, Corona, corrosion, etc., but the above methods are complicated, in order to reduce the process, people are often drawn nylon plus fiberglass primer water spray in the PA substrate, and then brushing the other coatings an effective method, and is convenient, economical, provincial, provincial paint. 

 Use 
 1 will have to deal with the PA material wipe clean and remove surface residual grease or release agent. 2 nylon and fiberglass primer water spray or wipe on the PP material to be processed to a dry film 5-10UM, put it aside for 5-10 minutes. (3) coating of ink or paint, put it aside for 5-10 minutes. Dried for 30 minutes 4. Coating nylon plus fiberglass primer water good workpiece 80 ℃ mandatory best. 

 Note 
 Nylon fiberglass primer water to avoid contact with eyes or skin, such as inadvertently stained, with plenty of water and soap and water when necessary and timely medical treatment. 2, nylon plus fiberglass primer water shelf life of 12 months, should be stored in a cool dark place in (30 ℃), a well-ventilated place away from sources of ignition. 3, nylon plus fiberglass primer water is turned on in a timely manner kept under seal to avoid failure 

 Product physical properties 

 Chemical composition: polymer interface polymer 
 Density (g/cm3): 0.90 
 Flash Point: about 12 ℃ 
 Appearance: light yellow transparent liquid Colorless transparent liquid 
 Taste: with the ordinary days that water taste 
 Product Use 

 Special additives to enhance coating adhesion to the substrate 1, specifically applied to the PA plastics processing. 
 2, PA products are widely used in many household appliances, commodity, toys, etc., in order to make products to achieve a high level in appearance, surface finishing, PA plastic surface is poor, low-polarity, often attached to focus on the poor, require special handling. Such as: Flame, Corona, corrosion, etc., but the above methods are complicated and high cost, in order to reduce the process, reduce costs, people are often drawn to the PA end of water sprayed on the PA substrate, and then brushing the other The coating is an effective and convenient, economic, provincial, provincial paint. 

 Use 

 Bottom water, the PA can be directly sprayed on the PA on, generally as long as the cross gun can, after construction of the PA in the indoor air dry for about 15min and then spray paint. 
 For small or complex shape PA plastic workpiece directly immersed in the water of the PA for a PA workpiece is removed, spray paint in the indoor air dry for about 20min. 
 The PA after the spraying, such as bake 30min at 80 ℃, the coating adhesion to the substrate can be better.