A. Description: rubber due to the non-polar material, using the usual glue is often difficult to achieve the desired result. The treatment agent in the surface treatment of the rubber material. This product can effectively improve the surface polarity of the rubber material, greatly improving the adhesive properties. Treated in the rubber fuel injection printing have a good effect. This product is a single component and two-component two models. 
 Two. Product performance: 1. Appearance: colorless, transparent, low viscosity organic solution. (Two-component type B powder) 2. The dilutional: polymer resin solution, plus the ester solvent dilution. 3. Stability: storage at room temperature for one year. 
 Three. How to use: 1. Single component model can be used directly. Use two-component powder B A solution to be used within 4 hours, stir. The two-component product is superior to the single component model. Two. For bonding the rubber parts of the polished rough. Cotton cloth (do not use synthetic cloth) dipped in rubber processing agents clamped with forceps, uniform coating in handling site. Room temperature for about 15 minutes to dry, put after drying better. For the processing of a large area of ??rubber products, you may consider spraying or roller coating. If only the fuel injection printing, and dry can. 3. Treatment agent, and drying over rubber material, to put down to room temperature and then gluing the temperature is too high on glue, can lead to glue the low boiling point solvent evaporation, the plastic bubble, reduce the adhesive strength. For enhanced results, use two-component models. 4. Please use this adhesive to be the trial, to avoid errors. Bonding deviations are requested to promptly contact the company as a result of material conversion or other special reasons